Bosch Appliances Microwave Oven DS820I User Manual

Installation Instructions  
DS820i/DS820iT Series  
TriTech PIR/Microwave Intrusion Detectors with Pet Immunity  
1.0 Description  
The DS820i and DS820iT Series are high performance TriTech Passive Infrared (PIR)/Microwave (MW) Intrusion Detectors which use advanced signal  
processing to provide outstanding catch performance and unsurpassed false alarm immunity. They are designed to detect movement of a human body in the  
interior of a structure as it moves across the Detector’s field of view. When motion is detected, the Detector sends an alarm signal to the control panel. With  
Bosch Security Systems Pet Friendly® pet immunity, these Detectors will not detect a dog up to 100 pounds (45 kg) or two 60 pound (27 kg) dogs, up to 10 cats,  
numerous rodents or flying birds. This pet immunity feature has not been tested by Underwriters Laboratories.  
Microwave Frequency:  
DS820i/820iT:  
DS820iTA:  
2.0 Specifications  
10.525 GHz (UL Listed)  
10.687 GHz (Export only, not UL Listed)  
Input Power:  
6 to 15 VDC, 16 mA nominal standby (up to 35 mA  
during walk testing and alarm). Use only Limited Power  
Source up to 5 A maximum.  
DS820iTB:  
Coverage:  
Tamper:  
9.9 GHz (Export only, not UL Listed)  
20 ft. by 20 ft. (6 m by 6 m)  
Standby Power: No internal standby battery. For UL Certificated  
installations, 4 hours (64 mAh) standby power must  
be provided by the control unit or by a Listed burglary  
power supply.  
(“T” models only) Normally Closed (with cover on).  
Contacts rated at 28 VDC, 125 mA max. Connect  
tamper circuit to a 24-hour protection circuit.  
Options:  
Patents:  
B335 Low Profile Swivel Mount Bracket , B338 Ceiling  
Mount Bracket. (The use of brackets is not  
recommended for pet applications and may reduce  
range and increase dead zone areas).  
Alarm Relay:  
Silent operating Normally Closed reed relay. Contacts  
rated 3 W, 125 mA, 28 VDC maximum for DC  
resistive loads; and protected by a 4.7 , 1/2 W  
resistor in the common “C” leg of the relay. Do not  
use with capacitive or inductive loads.  
This product is covered by one or more of the  
following U.S. patents: #4,660,024, #4,764,755,  
#5,077,548, #5,208,567, #5,262,783, #5,450,062,  
and #5,670,943.Other patents pending.  
Temperature:  
The storage and operating temperature range is  
-40°F to +120°F (-40°C to +49°C). For UL Certificated  
installations, the temperature range is +32°F to +120°F  
(0°C to +49°C).  
3.0 Installation  
3.3 Select a mounting location.  
Mount the sensor where an  
3.2 Press the vertical adjust tab  
toward the side of the base and  
lift out the board.  
3.1 Remove the cover using  
a small flat-blade  
intruder will most likely cross  
through the coverage pattern.  
screwdriver.  
LED ON  
Bottom of Detector  
7.5-9ft  
7.5-9ft  
Optional anti-tamper  
screws at each end  
Insert screwdriver here or here  
3.5 Observe the Pet Immunity mounting recommendations.  
3.4 Avoid:  
NOTE: The upper areas are  
not pet immune.  
Mounting  
Outdoors  
Direct Sunlight  
NO  
OK  
Direct Hot or  
Cold  
Drafts  
Pet  
Immune  
Area  
Moving Objects  
Windows  
and  
7.5 -9 ft.  
(2.3 - 2.7 m)  
Uninsulated  
Walls  
Heat  
Sources  
Air  
Mount the detector 7.5 to 9 feet  
(2.3 to 2.7 meters) above the floor  
Conditioning  
Outlets  
Don't point where pets can climb.  
 

Belkin Network Card F5D4079 8820ea05562 User Manual
Black Box Modem RF115 User Manual
Bogen Telephone DDU250 User Manual
Boss Audio Systems Car Stereo System BV9996BT User Manual
Boston Acoustics Speaker SoundWare User Manual
Brother Printer 580C User Manual
Califone MP3 Player 2395IR User Manual
Campbell Hausfeld Microcassette Recorder WG3000 User Manual
Carrier Weather Radio 500 T R User Manual
Casio PDAs Smartphones PA 2400W User Manual