Black Decker Hot Beverage Maker JK200 User Manual

®
Jug Kettle  
(Model JKA300 shown)  
Models JK200, JKA300 and JKA350  
For Descaling Instructions - See page 3  
Full Two Year Warranty - See page 3  
READ AND SAVE THIS BOOK  
Copyright © 1992 Black & Decker  
CONGRATULATIONS on your purchase of this fine product from Black &  
Decker.  
Please read these instructions carefully. They have been prepared to help you  
obtain the best results from this product.  
 
Removable Lid  
ON/OFF Switch  
(Models JKA300,  
JKA350 only)  
Removable  
Cordset Plug  
(Model JKA300 only)  
FIGURE 1  
Water level indicator  
HOW TO USE YOUR JUG KETTLE  
1. Kettle should always be unplugged when filling or adding water.  
2. Fill the kettle with water to the desired level. Do not overfill. If kettle is overfilled there is  
a risk of spillage or spitting. The kettle lid may be removed for filling if desired. The  
water level indicator will assist you to measure correct amount. (See Figure 1).  
3. Place kettle on a dry, flat surface. Ensure lid is in place securely.  
4. Never operate the kettle with less than one cup (250 mL) of water or without lid  
securely in place.  
5. For auto-off model JKA300 only, connect cordset into socket on the kettle just below  
the handle (See Figure 2). This is not required on the JK200 and JKA350 models as  
cord set is permanently fixed to kettle.  
6. Insert plug into a grounded 120V 60Hz power outlet. CAUTION: Do not place kettle  
on a heated stove, or on a hot electric or gas burner. For auto-off models JKA300  
and JKA350 depress the on/off switch button on top of the kettle to the ON (-) position.  
(see Figure 3). No switching is required for JK200.  
7. When the water has boiled, the kettle will switch off automatically (auto-off JKA300 and  
JKA350 models only). After a short delay the water can be brought back to a boil by  
resetting the switch back to the ON (-) position. The JK200 model kettle must be  
unplugged manually upon reaching a full boil. DO NOT ALLOW THE KETTLE TO BOIL  
DRY (See special instructions - clause 4 if this occurs).  
8. The auto-off JKA300 and JKA350 model kettles may be switched off at any time by  
either pushing the switch on top of kettle to the “OFF” position or by manually  
unplugging unit at electrical wall outlet at the power outlet. The JK200 model kettle  
must be switched off by manually unplugging the unit.  
9. Always unplug your kettle from electrical power outlet before pouring. The cordset on  
your JKA300 may be removed from the kettle for handling and pouring convenience.  
FIGURE 2  
FIGURE 3  
(Model JKA300 Only)  
(Models JKA300, JKA350 Only)  
 
HOW TO CARE FOR YOUR JUG KETTLE  
Wipe the durable polypropylene exterior and lid of the Kettle with a soft, damp cloth or  
sponge. Remove stubborn spots with a cloth moistened with mild liquid detergent. Do not  
use abrasive scouring pads or powders. NEVER IMMERSE KETTLE BODY IN WATER  
OR OTHER LIQUIDS. From time to time, dependent on the nature of your water, mineral  
deposits can build up on the inside of your kettle reducing boiling speed and efficiency. You  
can remove this build-up by using a commercial descaler (available at Black & Decker  
Authorized Service Depots) or by using vinegar and water in the following manner:  
• Half fill the Kettle with ordinary tap water.  
• Add 30 mL (1 fluid oz.) of white vinegar to the water in the Kettle.  
• Boil the mixture and allow it to stand for 30 minutes. Reboil the mixture and allow it to  
stand for a further 30 seconds. Repeat procedure again for a third time. (Note: In extreme  
cases this procedure may have to be repeated).  
• Empty, rinse well and use in the normal way.  
NOTE : Some type mineral deposits cannot be removed with a vinegar solution. Check  
your element surface for scale removal and use commercial descaler if necessary.  
WARRANTY  
To the original purchaser (or gift recipient) of this product for home use, Black &  
Decker Canada Inc., warrants that any part of the product which proves to be  
defective in material or workmanship within two years of the date of purchase or  
receipt wil be repaired or replaced, free of charge.  
Should your product not perform properly, return it to your nearest Black &  
Decker service depot, transportation charges prepaid. A list of authorized  
service depots is packaed with the appliance.  
If the nearest service depot is located outside of your city or metro area, or if  
you live in a rural area, Black & Decker Canada Inc. will pay the return  
transportation charges. This warranty will be honoured by any of our authorized  
service depots in Canada, wherever you may live, regardless of where the  
appliance was purchased.  
The provisions of this warranty are in addition to, and not a modification of or  
subtraction from the statutory warranties and other rights and remedies  
contained in any applicable legislation and to the extent that any such  
provisions purport to disclaim, exclude or limit any such statutory warranties or  
other rights or remedies, such provisions shall be deemed to be amended to the  
extent necessary to comply therewith.  
®
Black & Decker Canada Inc.  
100 Central Avenue.  
Brockville, Ontario K6V 5W6  
BEYOND WARRANTY SERVICE  
For beyond warranty repairs we recommend that you use our authorized  
service depots as these facilities carry replacement parts and have the proper  
servicing and test equipment for safe repairs.  
PRINTED IN HONG KONG  
Form No.: 263079-01  
 

Beko Washer Dryer WCB 77087 User Manual
Billy Goat Yard Vacuum KD512, KD512HC, KD512HCS User Manual
Bionaire Electric Heater BCH4830 CN User Manual
Boca Research Network Card 54M User Manual
Bosch Appliances Cooktop NGM User Manual
Brinkmann Gas Grill ProSeries 2310 User Manual
Brother All in One Printer Version A User Manual
Bush Hog Brush Cutter 320 Series User Manual
Cal Flame Outdoor Fireplace LTR20091006 User Manual
Campbell Hausfeld Air Compressor FP209699 User Manual